The bad part:
When I try to run some of my maps from DB2, they crash. Using r447 and earlier, as the test program, they run fine.
The good part:
Running any of those maps straight through GZDoom, they work fine.
[r451 r450] crash
Moderator: Graf Zahl
-
NeoHippo
- Posts: 408
- Joined: Tue Sep 13, 2005 0:47
- Location: British Columbia Canada
-
Rachael
- Developer
- Posts: 3651
- Joined: Sat May 13, 2006 10:30
Re: [r451 r450] crash
In case you haven't seen this the 1000 times before when Graf and Randy posted it:
Posting your maps helps. Lots.
Posting your maps helps. Lots.
-
Graf Zahl
- GZDoom Developer
- Posts: 7148
- Joined: Wed Jul 20, 2005 9:48
- Location: Germany
- Contact:
Re: [r451 r450] crash
I can't do much here without the precise WAD that is loaded while causing the crash (i.e the one DB temporarily saves.) It crashes while initializing the switches but if it's only happening from Doombuilder something very strange must be going on or Doombuilder loads another file along with the level that contains a corrupt definition.
-
NeoHippo
- Posts: 408
- Joined: Tue Sep 13, 2005 0:47
- Location: British Columbia Canada
Re: [r451 r450] crash ---> solved
This was not a problem with GZDoom or Doombuilder2. The file, which was referred to in local.txt of the crash report as WAD 3, must have been the offending culprit. Exactly why it happened, I do not know. I cleaned out the temp directory and all is working correctly again.
It was good, though, that it happened. Now I know the location, to where DB2 writes its backups.
It was good, though, that it happened. Now I know the location, to where DB2 writes its backups.